Post by Mark Aldrich on Feb 10, 2017 10:37:44 GMT -5
I thought someone else besides Formations had made these? I check TMD and Tank workshop but did not find them. These are the Resin stubs to replace the cut and stack foam ones in the Tasca kits.
I just use a hunk of styrene strip, Mark. Choose the thickness based on how much sag you want on the suspension. A Sherman with sandbags or spare track all over should be a little compressed all the way around. One with four to six inches of concrete slathered on the nose should sit a little down at the front. A worn-out Madill yarder should sit flat at the front and a bit high at the rear.
"You could probably use some armor. A Sherman can give you a very nice...edge!"
Post by Mark Aldrich on Feb 14, 2017 12:27:46 GMT -5
I did that on the FL10 and wasn't impressed. I ordered some from Formations and now I remember why I usually don't. Over a week and no notification if my order has shipped or not. Same with the Asuka store. Luckily, not in any big rush to start my M50 project.